12 February 2010 - 0:41Easy to install – Patio 101
Image : http://www.flickr.com
Whether you're on Masonite hardboard or center-hinged French patio doors, is the fact that there is an amazing new set of doors never reach their full potential leaning wall of your garage. If you got this far, then it is time to seriously mount patio doors. Not only should add some new features to your home, increase your sense of pride and achievement significantly, too!
In a few simple steps you can take your newdoors installed and working perfectly.
1st Set rough opening and frame size.
• Rough opening width is the framework for measuring internal Stud another enclosure.
• Rough opening height is measured in the subfloor below the header.
Do not go to the 2nd area is clean and smooth.
3rd Remove all packaging from your door (includes all screws at the top of the head).
4.Apply sealant to the flat surfaces of the lower limit, covering the bottom and the groove.
5th Fit units in rough opening.
• Do not attempt without assistance.
6th Shim and secure the unit.
• Shim down firmly and in the manual of your door. Shim the top of the device, as shown.
• Approve 1 / 8 "gap between the top frame and door header.
Isolate 7 and the installation.
• Overviewmat with a razor and snap-in flush with the frame.
• The insulation is no gap between the frame and rough opening with insulation fiberglass.
8th Drilling Tools
• Caulk all corners and around the wall. Sealing all externals Trim Trim meets the brick or siding.
9. I said there were 9 steps, right? Well, it's another step, I ask you a step back and admire your work, because you just installed a newPatio!
Tags : double door
Related Blogs
- Related Blogs on Easy to install – Patio 101
Related posts:
No Comments | Tags: Double Door